You can use line color on the geometry file to determine depth. If you have any trouble send me the files and I will see what I can do.ĭepending on the complexity of the file you may be able to use the export function of Mastercam to write a DXF file. (Check with Bruce Clarke on this) If you have arcs with 'r' as a modifier, The NCI file will have to be re-posted through Mastercam using a different post. The G-code converter will only convert arcs if their midifiers are I & J. One very important thing to consider is G02 or G03. If any drill cycles were used, 'G98' or 'G99' will have to be removed from the offending lines. ![]() Remove 'G43' and the 'H' value from that line. The next line will contain the code for setting the height offset for that tool. Remove Sxxx but keem the 'M03 if you have a relay to turn on the router.Also, keep the x and y locations on that line. This line will also contain the spindle speed. If the program you have contains 'G54' near the third line, this code needs to be removed. If it contains G90, keep that code.ĬNC machines use fixture offsets to tell the control where the origin of the part is. ![]() Near the top of the program is a line referred to as the 'Safety Block' It will include G40,G80,G49 etc. Mastercam will post a lot of code at the beginning of the program that is not needed by shopbot. ![]() Depending on what post processor was used a little editing will have to be done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |