Using logic regulation give free digital Arduino outputs: 8 and 12. ![]() The direct regulation provides control of L298N driver and uses 3 Arduino outputs for each channel. ![]() There is an individual switch for each channel. Use shield switches to change control mode. Logic control: Motor 1 - outputs: 9, 10(PWM)/ Motor 2 - outputs: 11(PWM), 13. Now, let’s design a small circuit and check out its controlling operation. It has two output pins on left and 2 on the right side, while the input pins are shown at the right bottom corner. Speed regulation is realized through PWM default mode, a signal can be applied by PWM Arduino outputs 10 and 11 (digital outputs complying PWM).ĭirect control: Motor 1 - outputs: 8, 9, 10(PWM)/ Motor 2 - outputs: 11(PWM), 12, 13 Using this L298 Motor Driver, you can easily control two DC Motors and it works exactly the same as our hardware L298 module. and it can drive two DC motors or a 4-wire 2-phase stepper motor. The driver has LED indicating rotational direction of each motor. This drive module integrates the two L298N chip, it can drive four DC motors (reversible, can use PWM to control speed) or two stepper motors. Package Include: 1x L298N Dual Channel DC Motor Driver Module Jual L298N L298 L 298. Motor Driver L298N for Arduino is based on L298P chip with voltage 5-36V and peak current up to 2A on each motor (channel). You can control each motor. Also, you may drive bipolar step motor current up to 4A. ![]() Motor Driver L298N for Arduino with Logic control system allows to control of 2 DC-motors, to control rotational speed, rotational direction, to stop motors with freewheeling or to block their action.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |